Watch this video, and use the instructions below to clean your Zebra P1X0i Card Printer.
The supplies you need for cleaning the P1X0i card printer are
- SM01105912-912 – Feed and Engine Cleaning Cards ( 4 Sets )
1. Leave the Printer power on, or turn it on if it was off.
2. Initiate the cleaning process by either of the following methods:
- At the printer, press and hold the Multi Function button for several seconds, until the LCD Panel displays the message REMOVE RIBBON THEN CLOSE LID.
- From the computer, enter the P1X0i Printer Tools software ( Right Click on the Printer Driver and select Properties, Select the Device settings Tab and the Tools – Properties option ) in the printer driver, and click on the CLEAN button.
3. The LCD Panel will display the message REMOVE RIBBON THEN CLOSE LID.
- Open the Main Cover, and remove the ribbon cartridge. Then close the Main Cover.
4. The LCD Panel will display the message EMPTY FEEDER THEN CLOSE COVER.
- Open the Card Feeder Cover and remove cards from the Card Feeder and close the cover.
5. The printer will display EJECTING CARD
- The printer will eject any card that has been pre feed
6. The LCD will display the message FEED LONG CLEANING CARD IN EXIT.
- Insert the long end of the Engine cleaning card into the card exit.
7. At the conclusion of this part of the cleaning process, the Cleaning Card will be ejected, and the LCD will display the message REMOVE LONG CLEANING CARD
8. The LCD will then display the message INSERT FEEDER CLEANING CARD.
- Place a pre-saturated Cleaning Card into the Card Feeder.
- While the cleaning process is underway, the LCD Panel will display the message CLEANING PRINTER.
- When the cleaning is complete the LCD will display REMOVE FEEDER CLEANING CARD
9. The LCD will request the cards and Ribbon be loaded in the printer
10. The LCD will display READY when complete.
10. Discard both cleaning cards after a single use.
Note : Do not use previously used cleaning cards.
0 comments:
Post a Comment